Difference between revisions of "Template:Slice Settings1"
From MatterControl Manual
| Line 1: | Line 1: | ||
| − | <noinclude>'''This is a duplicate template for use with duplicate slice settings (i.e. General -> Speed -> Support Material and Filament -> Extrusion -> Support Material). The associated file names have a 1 at the end of the base; that is the only difference. This and [[Template:Slice Settings]] should be edited at the same time.'''</noinclude>__NOTOC__{{DISPLAYTITLE:{{SUBPAGENAME}}}}[[File:{{SUBPAGENAME}}1-ss.png|right|frame|<center>A screenshot of the '{{SUBPAGENAME}}' setting as seen in MatterControl's Settings pane.</center>]] | + | __NOEDITSECTION__<noinclude>'''This is a duplicate template for use with duplicate slice settings (i.e. General -> Speed -> Support Material and Filament -> Extrusion -> Support Material). The associated file names have a 1 at the end of the base; that is the only difference. This and [[Template:Slice Settings]] should be edited at the same time.'''</noinclude>__NOTOC__{{DISPLAYTITLE:{{SUBPAGENAME}}}}[[File:{{SUBPAGENAME}}1-ss.png|right|frame|<center>A screenshot of the '{{SUBPAGENAME}}' setting as seen in MatterControl's Settings pane.</center>]] |
== Function == | == Function == | ||
<noinclude>Number 1 is the function as described in the help text, and/or Taylor's slicer settings article text</noinclude> | <noinclude>Number 1 is the function as described in the help text, and/or Taylor's slicer settings article text</noinclude> | ||
Revision as of 17:20, 11 February 2016
This is a duplicate template for use with duplicate slice settings (i.e. General -> Speed -> Support Material and Filament -> Extrusion -> Support Material). The associated file names have a 1 at the end of the base; that is the only difference. This and Template:Slice Settings should be edited at the same time.File:Slice Settings11-ss.png A screenshot of the 'Slice Settings1' setting as seen in MatterControl's Settings pane.
Function
Number 1 is the function as described in the help text, and/or Taylor's slicer settings article text {{{1}}}
Parameters
The format of input accepted. For example, layer height takes count or mm. {{{2}}}
Example(s)
An example of each of the parameters, including a screenshot. The first will be included in this template, and any subsequent parameters will need to be inserted on the actual page. See Settings/General/Layers-Surface/Outer Surface - Perimeters/Perimeters for an example of this in practice. {{{3}}}
