Difference between revisions of "CONTROLS/Tuning Adjustment"
From MatterControl Manual
< CONTROLS
| Line 16: | Line 16: | ||
When used during an active print, the extrusion multiplier modifies the extrusion flow rate (as defined in the [[#Formula|formula below]]). | When used during an active print, the extrusion multiplier modifies the extrusion flow rate (as defined in the [[#Formula|formula below]]). | ||
| − | This variable is different from that of the [[Settings/Filament/ | + | This variable is different from that of the [[Settings/Filament/Extrusion/Flow/Extrusion Multiplier|Extrusion Multiplier slice setting]] and will work in conjunction with it. For example, if the slicer setting is set at 1.06 and then the slider in Controls is used during the print and set to 1.08, the total result will be a multiplier of 1.1448 (1.06 * 1.08). |
=== Formula === | === Formula === | ||
Revision as of 14:42, 21 November 2016
Use the slider or enter a value and click Set.
Speed Multiplier
When used during an active print, the speed multiplier modifies the speeds as set under the Speed section in General settings by multiplying itself times each setting.
Range
- Low : 0.5
- High : 2.0
Extrusion Multiplier
When used during an active print, the extrusion multiplier modifies the extrusion flow rate (as defined in the formula below).
This variable is different from that of the Extrusion Multiplier slice setting and will work in conjunction with it. For example, if the slicer setting is set at 1.06 and then the slider in Controls is used during the print and set to 1.08, the total result will be a multiplier of 1.1448 (1.06 * 1.08).
Formula
The general extrusion flow formula: layer height / (filament area (pi*r²) * extrusion multiplier)
Range
- Low : 0.5
- High : 3.0
