Difference between revisions of "Start G-Code"

Revision as of 17:08, 14 December 2015

Automatic GCode Added Before/After Start GCode

MatterSlice adds certain automatically generated code before and after your custom start GCode. This normally where your temperature settings would be applied. MatterSlice will wait for the bed to warm up first. Then begin warming the extruder, run your custom start GCode, then wait for the extruder to finish heating.

If MatterSlice detects that you have any extruder heating commands (M104, M109) in your custom start GCde, it will remove these from the automatic GCode. Likewise for bed heating commands (M140, M190).

Here are some examples of the automatic GCode:

Before:

   ; automatic settings before start_gcode  
   G21 ; set units to millimeters  
   M107 ; fan off  
   M190 S95 ; wait for bed temperature to be reached  
   M104 T0 S210 ; start heating extruder 1  
   T0 ; set the active extruder to 0

After:

   ; automatic settings after start_gcode
   M109 T0 S210 ; wait for extruder 1 to reach temperature
   T0 ; set the active extruder to 0
   G90 ; use absolute coordinates
   G92 E0 ; reset the expected extruder position
   M82 ; use absolute distance for extrusion

Variables

MatterSlice allows you to place certain tokens in your custom GCode that will automatically be replaced with the appropriate values. Here is an example:

M109 S[temperature]

In this line, [temperature] will be replaced with the extruder temperature defined in your slice settings. These tokens can be enclosed in either square brackets [] or curly brackets {}, but for compatibility with other slicers we recommend square brackets.

Here is the list of currently available tokens:

temperature

bed_temperature

bed_remove_part_temperature

extruder_wipe_temperature

z_offset

retract_length

filament_diameter

first_layer_speed

infill_speed

max_fan_speed

min_fan_speed

min_print_speed

perimeter_speed

retract_speed

support_material_speed

travel_speed

bridge_fan_speed

bridge_speed

raft_print_speed

external_perimeter_speed