Difference between revisions of "Slic3r"
From MatterControl Manual
| Line 1: | Line 1: | ||
| − | '''Slic3r''' is a third-party slicing engine which has been integrated into MatterControl. | + | '''Slic3r''' is a third-party slicing engine which has been integrated into MatterControl. |
| + | |||
| + | == Origin == | ||
| + | |||
| + | Slic3r was created in 2011 by members of the RepRap community.<ref>[http://reprap.org/wiki/Slic3r Slic3r - RepRapWiki]</ref> | ||
| + | |||
| + | == Documentation == | ||
The complete list of available Slic3r slice settings for use in MatterControl can be found on the [[Slic3r Settings]] page. | The complete list of available Slic3r slice settings for use in MatterControl can be found on the [[Slic3r Settings]] page. | ||
| + | |||
| + | == Repository == | ||
| + | |||
| + | Slic3r is an open source project hosted on GitHub: https://github.com/alexrj/Slic3r | ||
| + | |||
| + | == References == | ||
| + | |||
| + | <references /> | ||
[[Category:Slice Engines]] | [[Category:Slice Engines]] | ||
| − | |||
Revision as of 16:22, 11 February 2016
Slic3r is a third-party slicing engine which has been integrated into MatterControl.
Contents
Origin
Slic3r was created in 2011 by members of the RepRap community.[1]
Documentation
The complete list of available Slic3r slice settings for use in MatterControl can be found on the Slic3r Settings page.
Repository
Slic3r is an open source project hosted on GitHub: https://github.com/alexrj/Slic3r
