Difference between revisions of "SETTINGS/General/Support Material/Support Options/Air Gap"
From MatterControl Manual
< SETTINGS | General | Support Material | Support Options
| Line 1: | Line 1: | ||
| − | {{Slice | + | {{Slice Settings1 |
|The distance to skip between the support (including [[Settings/General/Support Material/Support Options/Interface Layers|interface layers]]) and the model. For PLA and ABS a value between 0.1 and 0.3 generally works well. | |The distance to skip between the support (including [[Settings/General/Support Material/Support Options/Interface Layers|interface layers]]) and the model. For PLA and ABS a value between 0.1 and 0.3 generally works well. | ||
| − | In MatterControl 1.5, | + | In MatterControl 1.5, {{oldid|Settings/General/Support_Material/Support_Options/Air_Gap|1895|Z Gap}} was changed to Air Gap. Z Gap only worked in increments of the layer height. Air Gap can be any distance.|*millimeters (mm) |
| − | |*millimeters (mm) | + | |
Can be zero.| | Can be zero.| | ||
Revision as of 11:58, 8 March 2016
Function
The distance to skip between the support (including interface layers) and the model. For PLA and ABS a value between 0.1 and 0.3 generally works well.
In MatterControl 1.5, Z Gap was changed to Air Gap. Z Gap only worked in increments of the layer height. Air Gap can be any distance.
Parameters
- millimeters (mm)
Can be zero.
Example(s)
For this example, Support_test.stl is the model used.
mm
In this example, the distance between the top of the support material and the bottom of the model is 0.2 mm.
