Difference between revisions of "SETTINGS/General/Layers-Surface/Layer Height/First Layer Height"

Revision as of 12:37, 1 December 2016

A screenshot of the First Layer Height setting as seen in MatterControl's SETTINGS pane.

Function

The height of the first layer. A first layer taller than the default layer height can ensure good adhesion to the build plate.

Parameters

• millimeters (mm)
• percent [of Layer Height] (%)

Example(s)

mm

Used as the default if no parameter type is specified. Will create a first layer of the specified millimeters thick.

%

Must enter '%' after input to activate. Used to specify height of first layer relative to Layer Height as a percentage.