Difference between revisions of "SETTINGS/Printer/Print Leveling/Probe Settings/Z Offset"

From MatterControl Manual
Jump to: navigation, search
Line 5: Line 5:
 
=== Restrictions ===
 
=== Restrictions ===
  
*This section (Print Recovery) is not shown when [[SETTINGS/Printer/Features/Hardware/Has Hardware Leveling|Has Hardware Leveling]] is enabled as only one form of leveling can be used at a time.|*millimeters (mm)|
+
*Not shown when [[SETTINGS/Printer/Features/Hardware/Has Hardware Leveling|Has Hardware Leveling]] is enabled as only one form of leveling can be used at a time.|*millimeters (mm)|
  
 
=== mm ===
 
=== mm ===
  
 
In this example, the paper to be used during the manual bed probe is 0.1 mm thick.}}
 
In this example, the paper to be used during the manual bed probe is 0.1 mm thick.}}

Revision as of 18:34, 6 December 2016

A screenshot of the Z Offset setting as seen in MatterControl's SETTINGS pane.

Function

The thickness of the paper (or other calibration device) used to perform manual bed probe.

Restrictions

Parameters

  • millimeters (mm)

Example(s)

mm

In this example, the paper to be used during the manual bed probe is 0.1 mm thick.

Z Offset-ss-ex.png