Difference between revisions of "SETTINGS/Printer/Print Leveling/Probe Settings/Z Offset"

Revision as of 09:31, 1 August 2017

A screenshot of the Z Offset setting as seen in MatterControl's SETTINGS pane.

Function

The thickness of the paper (or other calibration device) used to perform manual bed probe.

Restrictions

• Not shown when Has Hardware Leveling is enabled as only one form of leveling can be used at a time.

Parameters

• millimeters (mm)

Example(s)

mm

In this example, the paper to be used during the manual bed probe is 0.1 mm thick.