Difference between revisions of "SETTINGS/General/Layers-Surface/Layer Height/First Layer Height"
From MatterControl Manual
< SETTINGS | General | Layers-Surface | Layer Height
(Created page with "{{Slice Settings |Sets the height of the first layer. It is often desirable to print a taller first layer to ensure a good solid adhesion to the build plate.|Millimeters or p...") |
|||
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |Sets the height of the first layer. It is often desirable to print a taller first layer to ensure a good solid adhesion to the build plate.| | + | |Sets the height of the first layer. It is often desirable to print a taller first layer to ensure a good solid adhesion to the build plate.|*millimeters (mm) |
| + | *percentage (%)| | ||
=== mm === | === mm === | ||
Revision as of 17:20, 18 December 2015
Function
Sets the height of the first layer. It is often desirable to print a taller first layer to ensure a good solid adhesion to the build plate.
Parameters
- millimeters (mm)
- percentage (%)
Example(s)
mm
Used as the default if no parameter type is specified. Will create a first layer of the specified millimeters thick.
%
Must enter '%' after input to activate. Used to specify height of first layer relative to Layer Height as a percentage.
