Difference between revisions of "SETTINGS/General/Infill/Advanced/Starting Angle"
From MatterControl Manual
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The | + | |The angle of the infill, measured from the X axis. Not used when bridging.|*degrees |
Can be zero.| | Can be zero.| | ||
Revision as of 12:55, 12 January 2016
Function
The angle of the infill, measured from the X axis. Not used when bridging.
Parameters
- degrees
Can be zero.
Example(s)
degrees
This infill is tilted 35 degrees from parallel.
