Difference between revisions of "SETTINGS/Printer/Custom G-Code/Resume G-Code"
From MatterControl Manual
< SETTINGS | Printer | Custom G-Code
| Line 7: | Line 7: | ||
=== G-Code === | === G-Code === | ||
| − | In this example, when the 'Resume' button is pressed after the print has been paused, the printer will set coordinates relative to the current position (G91), then move 10 mm down and extrude 10.8 mm of filament at a rate of 12,000 mm/minute (G1 | + | In this example, when the 'Resume' button is pressed after the print has been paused, the printer will set coordinates relative to the current position (G91), then move 10 mm down and extrude 10.8 mm of filament at a rate of 12,000 mm/minute (G1 Z-10 E10.8 F12000), then set coordinates to absolute positioning again (G90).}} |
Revision as of 13:55, 13 January 2016
Function
G-Code to be run when the print resumes after a pause.
Parameters
- G-Code
Will accept Custom G-Code variables.
Example(s)
G-Code
In this example, when the 'Resume' button is pressed after the print has been paused, the printer will set coordinates relative to the current position (G91), then move 10 mm down and extrude 10.8 mm of filament at a rate of 12,000 mm/minute (G1 Z-10 E10.8 F12000), then set coordinates to absolute positioning again (G90).
