Difference between revisions of "SETTINGS/General/Raft-Priming/Raft/Fan Speed"

Revision as of 12:55, 20 January 2016

A screenshot of the Fan Speed setting as seen in MatterControl's SETTINGS pane.

Function

The speed at which the cooling fan(s) will run during the printing of the raft, expressed as a percentage of full power.

Parameters

• percent (%)

While the value can be any whole number from 0-100, the following values will produce these effects:

0% : off
50% : half speed
100% : full speed

Example(s)

%

At 100% the cooling fan(s) will be on at full blast during the printing of the raft.