Difference between revisions of "SETTINGS/Printer/Features/Behavior/Z Can Be Negative"
From MatterControl Manual
m (MatterHackers moved page Slice Settings/Printer/Features/Firmware/Allow Negative Z to Settings/Printer/Features/Firmware/Allow Negative Z without leaving a redirect) |
m (MatterHackers moved page Settings/Printer/Features/Firmware/Allow Negative Z to Settings/Printer/Features/Behavior/Allow Negative Z) |
(No difference)
|
Revision as of 11:24, 15 November 2016
Function
Allows the printer to attempt going below 0 along the Z axis during the Software Print Leveling wizard, and disables related warnings. Does not override actual endstops, physical or software.
Parameters
- Boolean
Example(s)
Boolean
The check box is checked to use the function.
The check box is unchecked to leave the function unused.