Difference between revisions of "SETTINGS/General/Raft-Priming/Raft/Fan Speed"
From MatterControl Manual
< SETTINGS | General | Raft-Priming | Raft
m (MatterHackers moved page Settings/General/Skirt and Raft/Raft/Fan Speed to Settings/General/Raft-Priming/Raft/Fan Speed) |
m (MatterHackers moved page Settings/General/Raft-Priming/Raft/Fan Speed to SETTINGS/General/Raft-Priming/Raft/Fan Speed) |
(No difference)
|
Revision as of 13:37, 1 December 2016
Function
The speed at which the cooling fan(s) will run during the printing of the raft, expressed as a percentage of full power.
Parameters
- percent (%)
While the value can be any whole number from 0-100, the following values will produce these effects:
0% : off
50% : half speed
100% : full speed
Example(s)
%
At 100% the cooling fan(s) will be on at full blast during the printing of the raft.