Difference between revisions of "SETTINGS/General/Support Material/Support Options/Support Percent"

Revision as of 12:37, 1 December 2016

A screenshot of the Support Percent setting as seen in MatterControl's SETTINGS pane.

Function

The percentage of extrusion width that overlaps on the previous layer which will trigger support material generation.

This replaces the Amount setting which was deprecated starting in version 1.5.

Parameters

• percent (%)

Presets

• Little : 10%
• Standard : 50%
• Lots : 90%
• Custom : user-defined

Example(s)

percent

In this example, a layer with an extrusion width which hangs 50% off over the previous layer will have support material generated.