Difference between revisions of "SETTINGS/Printer/Print Leveling/Probe Settings/Z Offset"

Revision as of 14:47, 1 August 2017

A screenshot of the Z Offset setting as seen in MatterControl's SETTINGS pane.

The thickness of the paper (or other calibration device) used to perform manual bed probe.

Not shown when Has Hardware Leveling is enabled as only one form of leveling can be used at a time.

In this example, the paper to be used during the manual bed probe is 0.1 mm thick.

Revision as of 09:31, 1 August 2017 (view source) Tanderson (Talk \| contribs) m (Tanderson moved page SETTINGS/Printer/Print Leveling/Probe Settings/Manual Probe Paper Width to SETTINGS/Printer/Print Leveling/Probe Settings/Z Offset) ← Older edit		Revision as of 14:47, 1 August 2017 (view source) MatterHackers (Talk \| contribs) Newer edit →
Line 1:		Line 1:
−	{{Slice ~~Settings~~	+	{{Slice Settings1

	\|The thickness of the paper (or other calibration device) used to perform manual bed probe.		\|The thickness of the paper (or other calibration device) used to perform manual bed probe.