Difference between revisions of "SETTINGS/Filament"
From MatterControl Manual
< SETTINGS
(Created page with "Slice Settings found under this category apply to the filament used to create the print. It has three sub-categories: *Filament *Slice...") |
|||
| Line 1: | Line 1: | ||
| − | + | __NOTOC__Slice Settings found under this category apply to the filament used to create the print. | |
| − | + | == Sub-Categories == | |
| − | + | === [[Slice_Settings/Filament/Filament|Filament]] === | |
| − | + | === [[Slice_Settings/Filament/Extrusion|Extrusion]] === | |
| − | + | === [[Slice_Settings/Filament/Cooling|Cooling]] === | |
Revision as of 09:36, 18 December 2015
Slice Settings found under this category apply to the filament used to create the print.
