Difference between revisions of "SETTINGS/General/Infill/Advanced/Starting Angle"
From MatterControl Manual
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |Sets the starting angle of the infill. Not used when bridging.| | + | |Sets the starting angle of the infill. Not used when bridging.|*degrees (radian) |
Can be zero.| | Can be zero.| | ||
Revision as of 17:18, 18 December 2015
Function
Sets the starting angle of the infill. Not used when bridging.
Parameters
- degrees (radian)
Can be zero.
Example(s)
degrees
This infill is tilted 35 degrees from parallel.
