Difference between revisions of "SETTINGS/General/Speed/Speed for Infill/Top Solid Infill"
From MatterControl Manual
< SETTINGS | General | Speed | Speed for Infill
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The speed at which the [[Slice_Settings/General/Layers-Surface/Outer_Surface_-_Top_%26_Bottom/Top_Solid_Layers|top solid layers]] will | + | |The speed at which the [[Slice_Settings/General/Layers-Surface/Outer_Surface_-_Top_%26_Bottom/Top_Solid_Layers|top solid layers]] will print.|*millimeters per second (mm/s) |
*percentage [of [[Slice_Settings/General/Speed/Speed_for_Infill/Infill|Infill speed]]] (%)| | *percentage [of [[Slice_Settings/General/Speed/Speed_for_Infill/Infill|Infill speed]]] (%)| | ||
Revision as of 18:03, 18 December 2015
Function
The speed at which the top solid layers will print.
Parameters
- millimeters per second (mm/s)
- percentage [of Infill speed] (%)
Example(s)
mm/s
In this example, the top solid infill will print at 30 mm/s.
%
In this example, the top solid infill will print at 50% of the Infill speed (which if you can make out the blurred text is set at 40), so the final result will be 20 mm/s.
