Support Percent
From MatterControl Manual
< SETTINGS | General | Support Material | Support Options
Revision as of 12:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/General/Support Material/Support Options/Support Percent to SETTINGS/General/Support Material/Support Options/Support Percent)
Function
The percentage of extrusion width that overlaps on the previous layer which will trigger support material generation.
This replaces the Amount setting which was deprecated starting in version 1.5.
Parameters
- percent (%)
Presets
- Little : 10%
- Standard : 50%
- Lots : 90%
- Custom : user-defined
Example(s)
percent
In this example, a layer with an extrusion width which hangs 50% off over the previous layer will have support material generated.
