Z Offset
From MatterControl Manual
< SETTINGS | Printer | Print Leveling | Probe Settings
Revision as of 09:31, 1 August 2017 by Tanderson (Talk | contribs) (Tanderson moved page SETTINGS/Printer/Print Leveling/Probe Settings/Manual Probe Paper Width to SETTINGS/Printer/Print Leveling/Probe Settings/Z Offset)
Function
The thickness of the paper (or other calibration device) used to perform manual bed probe.
Restrictions
- Not shown when Has Hardware Leveling is enabled as only one form of leveling can be used at a time.
Parameters
- millimeters (mm)
Example(s)
mm
In this example, the paper to be used during the manual bed probe is 0.1 mm thick.
