SETTINGS/Filament

Revision as of 11:22, 18 December 2015 by MatterHackers (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Revision as of 11:22, 18 December 2015 by MatterHackers (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

The 'Filament' category of slice settings as seen in the MatterControl settings pane.

Slice Settings found under this category apply to the filament used to create the print.

Contents

Sub-Categories

Sub-Categories

Filament

Extrusion

Cooling

Last edited 6 years ago by Tanderson