First Layer Height

From MatterControl Manual
Jump to: navigation, search
A screenshot of the First Layer Height setting as seen in MatterControl's SETTINGS pane.

Function

The height of the first layer. A first layer taller than the default layer height can ensure good adhesion to the build plate.

Parameters

  • millimeters (mm)
  • percent (%)

Example(s)

mm

Used as the default if no parameter type is specified. Will create a first layer of the specified millimeters thick.

First Layer Height-ss-ex.png

%

Must enter '%' after input to activate. Used to specify height of first layer relative to Layer Height as a percentage.

First Layer Height-ss-ex1.png