First Layer Height
From MatterControl Manual
< SETTINGS | General | Layers-Surface | Layer Height
Revision as of 17:51, 21 December 2015 by MatterHackers (Talk | contribs)
Function
Sets the height of the first layer. It is often desirable to print a taller first layer to ensure a good solid adhesion to the build plate.
Parameters
- millimeters (mm)
- percent (%)
Example(s)
mm
Used as the default if no parameter type is specified. Will create a first layer of the specified millimeters thick.
%
Must enter '%' after input to activate. Used to specify height of first layer relative to Layer Height as a percentage.