Support Percent
From MatterControl Manual
< SETTINGS | General | Support Material | Support Options
Revision as of 12:12, 16 February 2016 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |The percentage of extrusion width that overlaps on the previous layer which will trigger support material generation. This replaces the Settings/General/...")
Function
The percentage of extrusion width that overlaps on the previous layer which will trigger support material generation.
This replaces the Amount setting which was deprecated in version 1.5.
Parameters
- percent (%)
Presets
- Little : 10%
- Standard : 50%
- Lots : 90%
- Custom : user-defined
Example(s)
percent
In this example, a layer with an extrusion width which hangs 50% off over the previous layer will have support material generated.
