XY Homing Position
From MatterControl Manual
< SETTINGS | Printer | Print Recovery | Recover Settings
Revision as of 17:23, 6 December 2016 by MatterHackers (Talk | contribs)
Function
Specify the X and Y coordinates where the printer can home the Z axis without interfering with the partially-completed print.
Note: Not shown when Has Hardware Leveling is enabled as G29 procedures could interfere with a partially-completed print.
Note: Not shown when Home Z Max is enabled as homing up would not interfere with a partially-completed print.
Parameters
- millimeters (mm)
Example(s)
mm
In this example, the best coordinates on the X and Y axes for the printer to home the Z axis are 185, 190.
