Infill Angle
From MatterControl Manual
< SETTINGS | General | Support Material | Support Options
Revision as of 13:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/General/Support Material/Support Options/Infill Angle to SETTINGS/General/Support Material/Support Options/Infill Angle)
Function
The angle at which the support material lines will be drawn.
Parameters
- degrees
Can be zero.
Example(s)
For this example, Support_test.stl is the model used.
degrees
In this example, the infill angle is 60 degrees as shown on the first layer of the model in 2D Layer View.