Amount
< SETTINGS | General | Support Material | Support MaterialRevision as of 11:37, 22 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings| The minimum angle of overhang for which support material will be created. The angle perpendicular to the bed {{=}} 0; parallel with the bed {{=}} 90.|*degre...")
Revision as of 11:37, 22 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings| The minimum angle of overhang for which support material will be created. The angle perpendicular to the bed {{=}} 0; parallel with the bed {{=}} 90.|*degre...")
Function
The minimum angle of overhang for which support material will be created. The angle perpendicular to the bed = 0; parallel with the bed = 90.
Parameters
- degrees
Can be zero.
Presets
- Minimum : 20
- Standard : 45
- All : 90
- Custom : user-defined
Example(s)
Parameter 1
The standard preset will generate support material for any overhang which is more than 45 degrees from perpendicular with the bed.
