Infill Angle
From MatterControl Manual
< SETTINGS | General | Support Material | Support Options
Revision as of 12:31, 22 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |The angle at which the support material lines will be drawn.|*degrees Can be zero.| For this example, [http://104.154.32.252/images/7/72/Support_test.stl...")
Function
The angle at which the support material lines will be drawn.
Parameters
- degrees
Can be zero.
Example(s)
For this example, Support_test.stl is the model used.
degrees
In this example, the infill angle is 60 degrees as shown on the first layer of the model in 2D Layer View.
