Extra Length On Restart
< SETTINGS | Filament | Retraction | While PrintingRevision as of 14:39, 30 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |Additional distance of filament to extrude after a retraction.|*millimeters (mm) Can be zero. Can be negative.| === mm === In this example, an additiona...")
Revision as of 14:39, 30 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |Additional distance of filament to extrude after a retraction.|*millimeters (mm) Can be zero. Can be negative.| === mm === In this example, an additiona...")
Function
Additional distance of filament to extrude after a retraction.
Parameters
- millimeters (mm)
Can be zero.
Can be negative.
Example(s)
mm
In this example, an additional 0.1 mm will be extruded after retraction.
