First Layer
< SETTINGS | Filament | Extrusion | Extrusion WidthRevision as of 11:50, 31 December 2015 by MatterHackers (Talk | contribs)
Revision as of 11:50, 31 December 2015 by MatterHackers (Talk | contribs)
Function
A modifier of the width of the extrusion for the first layer of the print.
A value greater than 100% can help with adhesion to the print bed.
Parameters
- millimeters (mm)
- percent (%)
Set to 0 to use default extrusion width.
Example(s)
mm
In this example, the adjusted nozzle diameter for the first layer extrusion will be .5 mm.
%
In this example, the nozzle diameter set under Printer settings will be modified by 110%. For this example, the nozzle size was 0.4 mm, so the adjusted size will be 0.44 mm.
