Outside Perimeters
< SETTINGS | Filament | Extrusion | Extrusion WidthRevision as of 11:50, 31 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |A modifier of the width of the extrusion when printing outside perimeters. Can be useful to...")
Revision as of 11:50, 31 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |A modifier of the width of the extrusion when printing outside perimeters. Can be useful to...")
Function
A modifier of the width of the extrusion when printing outside perimeters.
Can be useful to fine-adjust actual print size when objects print larger or smaller than specified in the digital model.
Parameters
- millimeters (mm)
- percent (%)
Set to 0 to use default extrusion width.
Example(s)
mm
In this example, the adjusted nozzle diameter for the first layer extrusion will be .3 mm.
%
In this example, the nozzle size set under Printer settings will be modified by 90%. For this example, the nozzle size was 0.4 mm, so the adjusted size will be 0.44 mm.
