Bridging Fan Speed

< SETTINGS‎ | Filament‎ | Cooling‎ | Fan Speed

Revision as of 12:27, 31 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |The speed at which the layer cooling fan will run when bridging, expressed as a percentage of full power.|*percent (%) Can be zero.| === % === In...")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Revision as of 12:27, 31 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |The speed at which the layer cooling fan will run when bridging, expressed as a percentage of full power.|*percent (%) Can be zero.| === % === In...")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

A screenshot of the Bridging Fan Speed setting as seen in MatterControl's SETTINGS pane.

Function

The speed at which the layer cooling fan will run when bridging, expressed as a percentage of full power.

Parameters

percent (%)

Can be zero.

Example(s)

%

In this example, the layer cooling fan will run at 50% of full power when creating a bridge.

Bridging Fan Speed-ss-ex.png

Last modified on 13 September 2018, at 17:01