Infill
Revision as of 17:12, 4 December 2015 by MatterHackers (Talk | contribs) (Created page with "A basic cube using [http://wiki.mattercontrol.com/CuraEngine Cura]'s infill pattern at 10%. '''Infill''' is the material used to fill the spa...")
Revision as of 17:12, 4 December 2015 by MatterHackers (Talk | contribs) (Created page with "A basic cube using [http://wiki.mattercontrol.com/CuraEngine Cura]'s infill pattern at 10%. '''Infill''' is the material used to fill the spa...")
A basic cube using Cura's infill pattern at 10%.
Infill is the material used to fill the space between the horizontal layers of a print. It can be assigned a percentage value from 0 to 100%, which changes the density of the material. It is used to increase structural integrity, and can also serve to add weight to a part. Depending on your Slice Engine, the infill pattern can be changed to suit your needs.