Infill

< SETTINGS‎ | General

Revision as of 12:55, 20 January 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Slice Settings/General/Infill to Settings/General/Infill without leaving a redirect)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Revision as of 12:55, 20 January 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Slice Settings/General/Infill to Settings/General/Infill without leaving a redirect)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

The Infill sub-category as shown in the MatterControl SETTINGS pane.

Infill is a sub-category of General settings which deal with how the inside(s) of the model will print.

Sub-sections

Infill

Slice_Settings/General/Infill/Infill has no subpages to list.

Advanced

Slice_Settings/General/Infill/Advanced has no subpages to list.

Last modified on 22 December 2016, at 11:00