Infill Angle
< SETTINGS | General | Support Material | Support OptionsRevision as of 12:55, 20 January 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Slice Settings/General/Support Material/Support Options/Infill Angle to Settings/General/Support Material/Support Options/Infill Angle without leaving a redirect)
Revision as of 12:55, 20 January 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Slice Settings/General/Support Material/Support Options/Infill Angle to Settings/General/Support Material/Support Options/Infill Angle without leaving a redirect)
Function
The angle at which the support material lines will be drawn.
Parameters
- degrees
Can be zero.
Example(s)
For this example, Support_test.stl is the model used.
degrees
In this example, the infill angle is 60 degrees as shown on the first layer of the model in 2D Layer View.
