Z Offset
< SETTINGS | Printer | Print Leveling | Probe SettingsRevision as of 12:56, 20 January 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Slice Settings/Printer/Print Leveling/Probe Settings/Manual Probe Paper Width to Settings/Printer/Print Leveling/Probe Settings/Manual Probe Paper Width without leaving a redirect)
Revision as of 12:56, 20 January 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Slice Settings/Printer/Print Leveling/Probe Settings/Manual Probe Paper Width to Settings/Printer/Print Leveling/Probe Settings/Manual Probe Paper Width without leaving a redirect)
Function
The thickness of the paper (or other calibration device) used to perform manual bed probe.
Parameters
- millimeters (mm)
Example(s)
mm
In this example, the paper to be used during the manual bed probe is 0.1 mm thick.
