Open main menu

First Layer Height

< SETTINGS‎ | General‎ | Layers-Surface‎ | Layer Height
Revision as of 13:22, 20 January 2016 by MatterHackers (Talk | contribs) (Text replacement - "[[Slice Settings/" to "[[Settings/")

Revision as of 13:22, 20 January 2016 by MatterHackers (Talk | contribs) (Text replacement - "[[Slice Settings/" to "[[Settings/")

A screenshot of the First Layer Height setting as seen in MatterControl's SETTINGS pane.

Function

The height of the first layer. A first layer taller than the default layer height can ensure good adhesion to the build plate.

Parameters

  • millimeters (mm)
  • percent (%)

Example(s)

mm

Used as the default if no parameter type is specified. Will create a first layer of the specified millimeters thick.

First Layer Height-ss-ex.png

%

Must enter '%' after input to activate. Used to specify height of first layer relative to Layer Height as a percentage.

First Layer Height-ss-ex1.png

Last modified on 5 September 2018, at 10:07