Open main menu

First Layer Height

< SETTINGS‎ | General‎ | Layers-Surface‎ | Layer Height
Revision as of 13:20, 1 August 2016 by MatterHackers (Talk | contribs)

Revision as of 13:20, 1 August 2016 by MatterHackers (Talk | contribs)

A screenshot of the First Layer Height setting as seen in MatterControl's SETTINGS pane.

Function

The height of the first layer. A first layer taller than the default layer height can ensure good adhesion to the build plate.

Parameters

Example(s)

mm

Used as the default if no parameter type is specified. Will create a first layer of the specified millimeters thick.

First Layer Height-ss-ex.png

%

Must enter '%' after input to activate. Used to specify height of first layer relative to Layer Height as a percentage.

First Layer Height-ss-ex1.png

Last modified on 5 September 2018, at 10:07