Support Percent
< SETTINGS | General | Support Material | Support OptionsRevision as of 13:25, 1 August 2016 by MatterHackers (Talk | contribs)
Revision as of 13:25, 1 August 2016 by MatterHackers (Talk | contribs)
Function
The percentage of extrusion width that overlaps on the previous layer which will trigger support material generation.
This replaces the Amount setting which was deprecated starting in version 1.5.
Parameters
- percent (%)
Presets
- Little : 10%
- Standard : 50%
- Lots : 90%
- Custom : user-defined
Example(s)
percent
In this example, a layer with an extrusion width which hangs 50% off over the previous layer will have support material generated.
