Open main menu

Flow

< SETTINGS‎ | Filament‎ | Extrusion
Revision as of 09:28, 15 November 2016 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings Subsection|the extrusion multiplier.}}")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Revision as of 09:28, 15 November 2016 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings Subsection|the extrusion multiplier.}}")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Flow is a section of the Extrusion sub-category in Filament settings which deals with the extrusion multiplier.

The Flow section.

Settings:

Last modified on 1 December 2016, at 12:37