First Layer Height
< SETTINGS | General | Layers-Surface | Layer HeightRevision as of 12:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/General/Layers-Surface/Layer Height/First Layer Height to SETTINGS/General/Layers-Surface/Layer Height/First Layer Height)
Revision as of 12:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/General/Layers-Surface/Layer Height/First Layer Height to SETTINGS/General/Layers-Surface/Layer Height/First Layer Height)
Function
The height of the first layer. A first layer taller than the default layer height can ensure good adhesion to the build plate.
Parameters
- millimeters (mm)
- percent [of Layer Height] (%)
Example(s)
mm
Used as the default if no parameter type is specified. Will create a first layer of the specified millimeters thick.
%
Must enter '%' after input to activate. Used to specify height of first layer relative to Layer Height as a percentage.
