Extruder

< SETTINGS‎ | Printer

Revision as of 12:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/Printer/Extruder to SETTINGS/Printer/Extruder)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Revision as of 12:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/Printer/Extruder to SETTINGS/Printer/Extruder)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

The Extruder sub-category as shown in the MatterControl SETTINGS pane.

Extruder is a sub-category of Printer settings which deal with options for each extruder. This sub-category is dynamic, and has a section for every extruder as specified by the value set in the Extruder Count. The first is named 'Extruder 1', the second 'Extruder 2', etc.

Sub-sections

Extruder X

Settings/Printer/Extruder/Extruder_X has no subpages to list.

Last modified on 1 December 2016, at 12:59