Open main menu

Z Offset

< SETTINGS‎ | Printer‎ | Print Leveling‎ | Probe Settings
Revision as of 17:27, 6 December 2016 by MatterHackers (Talk | contribs)

Revision as of 17:27, 6 December 2016 by MatterHackers (Talk | contribs)

A screenshot of the Z Offset setting as seen in MatterControl's SETTINGS pane.

Function

The thickness of the paper (or other calibration device) used to perform manual bed probe.

Restrictions

  • This section (Print Recovery) is not shown when Has Hardware Leveling is enabled as only one form of leveling can be used at a time.

Parameters

  • millimeters (mm)

Example(s)

mm

In this example, the paper to be used during the manual bed probe is 0.1 mm thick.

Z Offset-ss-ex.png
Last modified on 2 August 2017, at 13:53