Open main menu

Enable Recovery

< SETTINGS‎ | Printer‎ | Print Recovery‎ | Recover Settings
Revision as of 17:31, 6 December 2016 by MatterHackers (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Revision as of 17:31, 6 December 2016 by MatterHackers (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
A screenshot of the Enable Recovery setting as seen in MatterControl's SETTINGS pane.

Function

If enabled, MatterControl will attempt to recover a print in the event of a failure such as broken connection or loss of power.

Restrictions

  • This section (Print Recovery) is not shown when Has Hardware Leveling is enabled as G29 procedures could interfere with a partially-completed print.

Parameters

  • Boolean

Example(s)

Boolean

The check box is checked to use the function.

Enable Recovery-ss-ex.png

The check box is unchecked to leave the function unused.

Enable Recovery-ss-ex1.png

Last modified on 6 December 2016, at 17:31