Z Offset
< SETTINGS | Printer | Print Leveling | Probe SettingsRevision as of 17:34, 6 December 2016 by MatterHackers (Talk | contribs)
Revision as of 17:34, 6 December 2016 by MatterHackers (Talk | contribs)
Function
The thickness of the paper (or other calibration device) used to perform manual bed probe.
Restrictions
- Not shown when Has Hardware Leveling is enabled as only one form of leveling can be used at a time.
Parameters
- millimeters (mm)
Example(s)
mm
In this example, the paper to be used during the manual bed probe is 0.1 mm thick.
