Has Filament Runout Sensor
< SETTINGS | Printer | Features | HardwareRevision as of 16:11, 31 July 2017 by Tanderson (Talk | contribs) (Created page with "{{Slice Settings |The printer has a switch for detecting when it has run out of filament. The print is paused if runout is detected. For this feature to work, the firmware m...")
Function
The printer has a switch for detecting when it has run out of filament. The print is paused if runout is detected.
For this feature to work, the firmware must support reporting the status of the runout sensor using the M119 command. The sensor must be labeled ros_0. TRIGGERED state defines filament has run out. When runout is detected the Pause G-Code is run.
Parameters
- Boolean
Example(s)
Boolean
The check box is checked to use the function.
The check box is unchecked to leave the function unused.
