Open main menu

Time For Extra Length

< SETTINGS‎ | Filament‎ | Retraction‎ | While Printing
Revision as of 17:43, 31 July 2017 by Tanderson (Talk | contribs) (Created page with "{{Slice Settings |The time over which to increase the Extra Length On Restart to it's maximum value. Below this time only a portion of the extra length will be applied. Leave...")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Revision as of 17:43, 31 July 2017 by Tanderson (Talk | contribs) (Created page with "{{Slice Settings |The time over which to increase the Extra Length On Restart to it's maximum value. Below this time only a portion of the extra length will be applied. Leave...")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
A screenshot of the Time For Extra Length setting as seen in MatterControl's SETTINGS pane.

Function

The time over which to increase the Extra Length On Restart to it's maximum value. Below this time only a portion of the extra length will be applied. Leave 0 to apply the entire amount all the time.

Parameters

  • seconds (s)

Can be zero.

Example(s)

Time For Extra Length-ss-ex.png
Last modified on 9 April 2019, at 10:15