Leveling Solution
< SETTINGS | Printer | Print Leveling | Machine SettingsRevision as of 14:20, 1 August 2017 by MatterHackers (Talk | contribs)
Revision as of 14:20, 1 August 2017 by MatterHackers (Talk | contribs)
Function
The print leveling algorithm to use when the Software Print Leveling wizard runs.
Restrictions
- Not shown when Has Hardware Leveling is enabled as only one form of leveling can be used at a time.
Parameters
Available as presets only:
- 3-Point Plane
- 7-Point Disk
- 13-Point Disk
- 3x3 Mesh
Example(s)
3-Point Plane
In this example, the printer will use the 3-Point Plane algorithm during the Software Print Leveling wizard.
7-Point Disk
In this example, the printer will use the 7-Point Disk algorithm during the Software Print Leveling wizard.
13-Point Disk
In this example, the printer will use the 13-Point Disk algorithm during the Software Print Leveling wizard.
3x3 Mesh
In this example, the printer will use a 3x3 grid pattern (9 total points) to probe the bed during the Software Print Leveling wizard.
