Raise-Stow

< SETTINGS‎ | Printer‎ | Print Leveling‎ | Probe Settings

Revision as of 09:27, 2 August 2017 by Tanderson (Talk | contribs) (Created page with "{{Slice Settings |This is the angle that raises or stows the Z probe.|*Degrees| }}")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Revision as of 09:27, 2 August 2017 by Tanderson (Talk | contribs) (Created page with "{{Slice Settings |This is the angle that raises or stows the Z probe.|*Degrees| }}")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

A screenshot of the Raise-Stow setting as seen in MatterControl's SETTINGS pane.

Function

This is the angle that raises or stows the Z probe.

Parameters

Degrees

Example(s)

Last modified on 2 August 2017, at 13:37